Concrete Driveway Cost in Madera, CA

A concrete driveway in Madera typically costs $6 to $12 per square foot installed for plain gray broom finish, and $10 to $22 for stamped or decorative work. A standard 600 square foot two-car driveway usually lands between $3,600 and $7,200 before tear-out.

The local price bands, and where they come from

These are Madera and Fresno-area figures, not national averages dressed up as local ones.

• Plain broom finish: $6 to $12 per square foot installed. Fresno-area published figures show unreinforced at $7 to $12 and reinforced at $8 to $13, and Madera-published local figures match the $6 to $12 band.
• Colored concrete: the upper end of the plain band into the low decorative band.
• Stamped and decorative: $10 to $22 per square foot installed, with local published figures running $10 to $18 and up to $12 to $22 for full stamped work.
• Tear-out of an old slab: $1.40 to $2.20 per square foot on Fresno-area published figures.

For comparison, national 2026 averages run $5 to $8 plain, $8 to $14 basic decorative, and $14 to $21 and up for mid to high-end work. Those are national numbers. Quote a Madera job from the local bands.

Worked examples at real driveway sizes

All in plain broom finish, poured fresh without tear-out:

• 12 ft x 30 ft single-car (360 sq ft): Fresno-area published range $2,400 to $4,400.
• Standard two-car (about 600 sq ft): usually $3,600 to $7,200.
• 24 ft x 40 ft wide two-car (960 sq ft): published range $6,300 to $11,600.
• 24 ft x 60 ft long rural approach (1,440 sq ft): published range $9,500 to $17,500.

Replacing an existing driveway adds demolition. On a 600 square foot slab, figure roughly $840 to $1,320 more for break-out and haul-off, which is why full removal and replacement usually totals $4,500 to $8,500 for a two-car. The tear-out side of that work is detailed on our concrete removal and replacement page.

What moves your driveway price up or down

Tear-out

A fresh pour on open ground is the cheapest case. Breaking out 40-year-old concrete, loading it, and paying disposal is real added scope.

Thickness and reinforcement

Standard car driveways get 4 inches of 4,000 PSI mix. If you park a heavy truck or an RV, the slab goes 5 to 6 inches with rebar on center, and the price follows the extra concrete and steel.

Size and access

Cost per square foot drops as size rises, because mobilization spreads across more concrete. Long rural approaches out toward Madera Ranchos carry big totals but efficient unit prices. Tight access that forces pumping or wheeling raises labor.

Finish

Broom finish is the baseline. Integral color adds a few dollars per square foot. Stamping adds pattern labor, color hardener, release agent, and sealer, which is how the decorative band reaches $22.

Base conditions

Soft subgrade, roots, or bad drainage discovered during tear-out changes the prep scope. We tell you before proceeding, in writing.

The permit line item

Concrete entirely on your property needs no encroachment permit. The moment the approach touches the public right of way, one applies: through the City of Madera Engineering Division inside city limits, where the minimum permit fee is $202, or through Madera County for addresses in Madera Acres, Madera Ranchos, and the other unincorporated areas. We pull the permit and build the approach to the governing standard drawings.

How to compare driveway bids

Compare scopes, not bottom lines. A real driveway bid itemizes tear-out and disposal, base rock and compaction, thickness, reinforcement, finish, joints, curing, and the permit if one applies. When a bid comes in far under the local band, one of those lines is missing, and it is usually the base.

The full specification of what goes under and into our slabs, base depth, steel, joint timing, and hot weather practice, is laid out on our Madera concrete driveway page.

Ready for a real number instead of a range? Call 559-254-0253. We measure on site and quote flat, in writing, free.